Epson C82357 - Manual (Page 25)

This chapter explains how to use EPSON Status Monitor 2.
Making Status Monitor Settings
You can change the settings in EPSON Status Monitor 2 by
following the instructions below.
1. Open the Run dialog box from the Start menu or the Control
Panel depending on your system. Type the path to the
directory where you installed the Status Monitor, followed
by Setup. Then click OK.
When you have installed the program in directory ESM2 of
drive C, type C:\ESM2\SETUP.
Note:
If you installed the program in a directory other than ESM2, type
the path to the directory instead of ESM2. If you installed the
program in drive C, type C: \ (path) \SETUP.
2. Follow the instructions on the screen.
NT 3.51 & 4.0:
Users can individualize their own settings without affecting the
settings of other users.
2-2 Using EPSON Status Monitor 2