Grass Valley XtenDD Ordering Guide - Manual (Page 37)

36 XtenDD Ordering Guide XtenDD Ordering Guide 37
Outputs and Aux-Buses
Equipping the basic mainframe with outputs or upgrading a package with aux buses requires the necessary
hardware (serial output modules and aux-bus modules) and a software license that enables the auxiliary
busses. The serial output modules are identical except for the labeling of the BNC connectors. The aux-bus
modules are also identical. Maximum seven modules can be installed. Configurations are possible with the
following quantity of auxiliary buses: 5, 10, 15, 20, 26, 32, 38.
RC 3450 Order no: 0 212 345 010
F0-212345-010
Serial Output 1
Module with BNC connectors for 10 aux buses (labeled as AUX1 – AUX 10)
plus the direct outputs (PGM 2x, PVW, Clean) for M/E-1 and P/P.
RC 3451 Order no: 0 212 345 110
F0-212345-110
Serial Output 2
Module with BNC connectors for 10 aux buses (labeled as AUX11 – AUX 20)
plus the direct outputs (PGM 2x, PVW, Clean) for M/E-2 and M/E-3.
RC 3452 Order no: 0 212 345 210
F0-212345-210
Serial Output 3
Module with BNC connectors for 18 aux buses (labeled as AUX21 – AUX 38).
RY 3435 Order no: 0 212 343 510
F0-212343-510
Aux Bus Processor Module
Mezzanine board, mounts on the aux bus motherboard, provides phasing,
safe-area and center cross insertion, and (switchable) H/V blanking.
One module is required per set of 5/6 aux buses.
LK0123 S Order no: 0 157 410 247
F0-157410-247 initial order only
No. of aux buses: five. License for five aux buses. Enables AUX1 – AUX5.
LK0124 S Order no: 0 157 410 206
F0-157410-206 initial order only
No. of aux buses: 10. License for 10 aux buses. Enables AUX1- AUX10
This hardware is
strongly recommended/
needed for all XtenDD
configurations.
This hardware is
strongly recommended/
needed for 3 and 4
M/E configurations.