Grass Valley LDK 7500 User Guide - Manual (Page 62)

6-8 FilmStream mode Viper
Files Menu Features
A user of the LDK 7500 camera can have access to 15 different files. This
number can be extended by using additional scene file smart cards. The
Files menu is used to recall and store these files.
There are two types of file; scene files and operator files. A scene file
contains values related to the picture performance. The operator file
contains values related to the set-up of the camera (viewfinder, lens
and installation parameters). The appendix indicates the functions that
are stored in the scene file and those functions that are stored in an
operator file.
Scene files
Four scene files are stored in the camera itself (SCAM1, SCAM2, SCAM3
and SCAM4). Another four scene files can be stored on the smart card
(SCARD1, SCARD2, SCARD3 and SCARD4). The default file names can
be changed in the files menu. A STANDARD scene file (preselected as
either factory or customer defined) is stored in the camera.
Note:
The standard customer scene file is stored via the Security menu, not
the Files menu. The decision to use the factory defined file or the
customer defined file as the standard file is also made in this menu.
The Files menu enables the scene files to be stored and recalled using
the store and recall entries of the menu system.
If the message NOK is displayed then the old values are restored. If the
camera is recording when a scene file is recalled then the recalled
values do not become active until the camera stops recording.
Operator files
The Files menu also allows the recall of the opererator file stored in the
camera (OCAM1) or one of the two operator files (OCARD1 and
OCARD2) stored on the smart card. These files contain information for
setting up the non-video configuration of the camera.
Files Menu