Grass Valley LDK 7500 User Guide - Manual (Page 33)

Controls FilmStream mode 4-3
Power source switch
Power can be supplied to the camera in either of two ways:
•
via the multicore cable and connector, or
• directly, via the DC IN power socket on the rear of the camera.
Set the power source switch at the rear of the camera to the position
that corresponds to you chosen method:
Ext. : Powered via DC IN socket
Multi : Powered via multicore
Power on indicator
The power indicator lights when power is supplied to the camera and
the camera power is switched on.
Circuit breaker button
If excessive current flows the circuit breaker shuts off the power. If this
happens check for faults and if necessary take corrective action before
pressing the circuit breaker button to reset the power.
Power output socket
This socket provides a nominal +12 Vdc supply (20VA max.) for
powering accessories.
Power input socket
This socket accepts a DC supply of 12V Nominal (11V to 17V) to power
the camera. Nominal power consumption is 44W.
Caution
The input voltage must not exceed 17 Vdc.
2
3
4
5
6