Grass Valley XG Vertigo Configuration Guide v.5.0 - Manual (Page 89)

5-34 Vertigo XG Configuration Guide
Dashboard - Vertigo XG’s Local Configuration Software
Hardware Settings > Video page
The Video page is a sub-page of the Hardware Settings tab, which is only visible when a
Vertigo hardware device is selected in the Dashboard’s device list. The Video page (figure
5-15 ) exposes parameters that allow you to set the Vertigo device’s video input/output
channels and video processing options.
Figure 5-15. The Video page within Dashboard’s Hardware Settings
I NPUT C HANNELS Specifies the input channel of the hardware to use. Depending on the
hardware configuration of the machine, the possible values are blank, A,
or B.
When running a single instance of the Vertigo device, both sources can be
used. But when running two instances of the device simultaneously, they
must each use a different input channel. In the case where there are more
instances running than input channels, some will have to leave the setting
blank.
O UTPUT C HANNELS Specifies the output channel of the hardware to use. Depending on the
hardware configuration of the machine, the possible values are A or B.
When running multiple instances of the Vertigo device simultaneously, each
instance must specify a different output channel. This parameter can also
be set using the Output Channel field on the Device Profile page (
page
5-15 ).
B IT C OUNT Specifies the bit depth of the signal. Choose either 8 or 10 (default) from the
drop-down list.