Grass Valley XG Vertigo Configuration Guide v.5.0 - Manual (Page 67)

5-12 Vertigo XG Configuration Guide
Dashboard - Vertigo XG’s Local Configuration Software
M ANUAL P ORT I NFORMATION
• S TARTING P ORT : Specifies the port number to use as the starting point
for searching for devices.
• P ORTS TO SCAN : Specifies the number of ports to scan starting at the
port number specified in the Starting Port.
IP I NFORMATION
Displays a list of IP addresses to scan to detect Vertigo devices. The IP
address is that of the machine that the device is running on. You can get this
IP address either by typing IPConfig on the command prompt, or by using
the IP address listed on the Vertigo device’s software’s dialog box.
•
A DD : Enter a specific IP address that you suspect the device to be
using.
• S ORT : Arranges the IP addresses added to the IP information list in
descending numerical order.
• R EMOVE : Removes the selected IP address from the IP Information list.
A UTOMATIC The device discovery’s automatic mode performs a thorough search for all
of the Vertigo devices on your local machine or on your network.
•
O NLY S CAN L OCAL M ACHINE : Rather than searching for all of the
Vertigo devices on your network, this setting limits the search to finding
all the Vertigo devices connected/on your local machine.
• T IME OUT : Sets a time limit at which to stop the search for devices. The
default value is 5 seconds.
D EVICE M ONITORING R EFRESH R ATE : Sets the frequency (in seconds) at which to poll the devices
to see if they are active or inactive. The default value is 10 seconds. See
“Monitoring the status of a device” on page 5-10 for more information.
A UTO -S AVE D EVICE L IST
ON E XIT
The Auto-Save Device List on Exit automatically saves the device list when
you exit Dashboard. By default this parameter is not enabled. See
“Saving
the device list” on page 5-9 for more information.