Grass Valley XG Vertigo Configuration Guide v.5.0 - Manual (Page 13)

2-2 Vertigo XG Configuration Guide
Overview of the Vertigo XG’s Hardware
The Vertigo XG’s front panel components
The Vertigo XG’s front panel features convenient access to the hard drives, a CD/DVD
ROM drive, and a control panel containing six LEDs and two buttons for system monitoring
and operation. The table following the figure
2-1 describes the function of each LED and
button.
Figure 2-1. The Vertigo XG’s front panel components
P OWER F AILURE Indicates a power supply module has failed, which is accompanied by an
audible alarm. A backup power supply module will take the load and keep
the system running, but the failed module will need to be replaced. This
red LED should be off when the system is operating normally.
O VERHEAT / F AN F AIL When this red LED flashes, it indicates a fan failure. When it is constantly
illuminated (solid on), it indicates an overheat condition, which may be
caused by cables obstructing the airflow in the system or the ambient room
temperature being too warm. Check the routing of cables and make sure
that all fans are present and operating normally. You should also check to
make sure that the chassis covers are installed properly. Finally, verify that
the heatsinks are installed properly. This LED will remain flashing or on as
long as the above mentioned conditions exist.
LAN2 A flashing green LAN2 LED indicates network activity on LAN2.
POWER
CD/DVD ROM Drive
Hard Drives Floppy
Drive