Grass Valley XG Vertigo Configuration Guide v.5.0 - Manual (Page 19)

2-8 Vertigo XG Configuration Guide
Overview of the Vertigo XG’s Hardware
GPI Card Connector Vertigo XG hardware option: Vx-GPI-8-e
The GPI card allows for control of the Vertigo XG via GPI triggers. The
card provides for up to 8 optically isolated GPI inputs and 8 reed relay
GPI outputs.
Port A is an 8 bit input port connected to optically isolated inputs
sensors. Each sensor can be used to interface a voltage and then
sense whether the voltage is on or off.
The reed relays are well suited for low current applications. The relays
are normally open, and will close when energized.
The following tables identify the pinout assignment for the GPI card’s
input and output ports:
Input Ports Pin Assignment Output Ports Pin Assignment
Power and Ground Pin Assignments