Grass Valley PDX 208 - Manual (Page 45)

Removing the Top Cover
PDX208 Instruction Manual 3-13
To install a new Disk Drive LEDs cable:
1. Connect the new Disk Drive LEDs cable from the LED board to the SCSI
Distribution board (Figure 3-7).
2. Replace the caddies previously removed.
3. Position the LED board over the mounting posts on the front panel and firmly press
down until the board snaps into place (Figure 3-6).
4. Raise the front panel and secure with the screws previously removed (Figure 3-4).
5. Position the front panel bezel mounting posts over the holes in the front panel and
press firmly until the bezel snaps back in place (Figure 3-1).
Removing the Top Cover
Figure 3-8 shows removal of the top cover, which must be removed to access the
interior for removal of other parts. To remove the top cover, refer to Figure 3-8 and:
1. Remove the PDX208 from the equipment rack.
2. Remove the cover mounting screws.
3. Lift the cover up and off the chassis.
Figure 3-8. PDX208 Top Cover Removal
9687-9