Grass Valley PDX 208 - Manual (Page 38)

Chapter 3 Service
3-6 PDX208 Instruction Manual
Removal and Replacement Procedures
This section identifies the replaceable parts of the PDX208 and the procedures to
remove and replace them.
NOTE: Do not discard any hardware unless specifically instructed to do so.
WARNING: Insure that the power cord is disconnected prior to performing any
removal and replacement procedure.
Replaceable Parts
Table 3-1 lists the PDX208 replaceable parts. Figure 3-3, keyed to Table 3-3, shows
the parts.
Removal and replacement procedures begin with the parts listed below, which do not
require removal of the PDX208 from the equipment rack.
• Front panel bezel (item 14 in Table 3-1)
• Air Filter (item 13 in Table 3-1)
• Video Disk Drive (item 4 in Table 3-1)
• Disk Drive Caddie (item 5 in Table 3-1)
• LED board assembly (item 11 in Table 3-1)
• LED Cable Assembly (item 12 in Table 3-1)
Table 3-1. PDX208 Replaceable Part List
Key Part Number Description
1 119-5195-XX Power Supply
2 119-4827-XX Fan, DC
3 671-4120-XX SCSI Distribution Board, Single Ended
4 119-5638-XX Video Disk Drive, 9 GB, Single Ended
5 407-4478-XX Disk Drive Caddie
6 174-3748-XX Cable, Power Supply to SCSI Distribution Board
7 174-3612-XX Cable, Line In to Power Supply
8 174-3586-XX Cable, Line In/Switch to Power Supply
9 174-3668-XX Cable, SCSI Internal/External
10 174-3751-XX Cable, Disk Drive to LED
11 671-3948-XX LED Board Assy, PDX208
12 174-3616-XX Cable Assy, LED
13 378-0432-XX Air Filter
14 333-4222-XX Front Bezel
!