Grass Valley PDX 208 - Manual (Page 23)

PDX208 to Profile Connections
PDX 208 Instruction Manual 2-7
To connect one PDX208 to one 4-channel PDR200, refer to Figures 2-6 and 2-7 and:
1. Connect a SCSI cable from the PDR200 rear panel connector on the Master
Enhanced Disk Recorder board (Slot J9) to one of the SCSI Bus 2 connectors on
the PDX208.
2. Connect another SCSI cable from the PDR200 rear panel connector on the Slave
Enhanced Disk Recorder board (Slot J10) to one of the SCSI Bus 1 connectors on
the PDX208.
3. Connect Terminators to the unused SCSI Bus 1 and SCSI Bus 2 connectors on the
PDX208.
The PDX208 connection shown in Figure 2-7 provides four 9GB disk drives to the
SCSI A bus on the Master Disk Recorder board and four 9GB disk drives to the SCSI
C bus on the Slave Disk Recorder board (or SCSI B bus on a PDR100).