Grass Valley PDX 208 - Manual (Page 24)

Chapter 2 Installing
2-8 PDX208 Instruction Manual
Connecting a PDX208 to a 2-Channel Profile
Figure 2-8 shows a PDX208 connection to a 2-channel Profile (i.e., without the Slave
Disk Recorder board). If connecting to a PDR100 Profile, see the configuration
stickers below the rear panel slots for the location of the Disk Recorder board. To
connect a PDX208 to a 2-channel Profile, refer to Figure 2-6 and Figure 2-8 and:
1. Connect a SCSI cable from the SCSI A bus on the Master Disk Recorder board
(Slot J9) to one of the SCSI Bus 2 connectors on the PDX208.
2. Connect another SCSI cable from the second SCSI Bus 2 connector on the
PDX208 to one of the SCSI Bus 1 connectors on the PDX208 as shown in Figure
2-8.
3. Connect a Terminator to the unused SCSI Bus 1 connector on the PDX208.
Figure 2-8. Example of PRX208 Cable Connections to a 2-channel Profile
The connection shown in Figure 2-8 provides eight 9GB disk drives to the SCSI A
bus of the 2-channel Profile.
J9
9687-4
Terminator
SCSI Cable
PDX208
PDR200