Grass Valley Profile Family 18GB Disk Drive Upgrade - Manual (Page 34)

Installing the SCSI Cable and Disk Drives
34 18GB Disk Drive Upgrade
To install the SCSI cable in a Profile system with a new Slave EDR installed:
1. Remove the adhesive backing on the cable clamp and attach it to the top of
the power supply parallel to and adjacent to the existing clamp.
2. Connect one end of the SCSI cable to the unused connector on the SCSI
backplane (
Ê in Figure 9).
Figure 9. Installing the SCSI Cable In a Profile System With a Slave EDR Board
3. Position the cable in the clamp so that both SCSI cables are parallel.
4. Remove PCI Interconnect board, if installed, by pulling it straight up and off
the boards. Refer to Figure 10 to help identify the PCI Interconnect board.
Your system may use a 5-slot PCI Interconnect.
5. Connect the free end of the cable to the top-rear SCSI header connector of
the Slave EDR board (
Ë in Figure 9).
6. Noting the connector keying, reinstall the PCI board so that the MASTER
connector on the PCI board is connected to the Master EDR board. (Refer to
Figure 10.)
0563-2
2
1