beautypg.com

Removing the top covers – Grass Valley Profile Family 18GB Disk Drive Upgrade User Manual

Page 26

background image

Installing the SCSI Cable and Disk Drives

26

18GB Disk Drive Upgrade

Removing the Top Covers

Use the following procedure to remove both chassis covers:

1. Confirm that the Profile system power is switched off and the power cord is

removed.

2. Use the Torx tool with the T10 tip to remove the top screws from the front

chassis cover (

Ê in Figure 5) and then use the T15 tip to remove the

pan-headed screws from the side of the chassis. The front chassis cover must
be removed first because it overlaps the rear chassis cover.

3. Use the Torx tool with the T10 tip to remove the rear chassis cover

(

Ë in Figure 5) which covers the circuit boards.

NOTE: Take care not to lose the chassis screws—they are required to meet
EMI specifications for the Profile system. Your system may contain more or
less screws in the front cover than shown in Figure 1
depending on how many
disk drives are installed.