Grass Valley NV9606 v.1.1 - Manual (Page 46)

36
Operation
Operating Concepts
Takes
Pressing a source button completes a take, in any mode, unless source preview mode is active.
In that case, it is necessary to press a ‘Take’ button to complete the take.
The NV9606 can operate by itself as a stand-alone panel or as an extension to an NV9607. As an
extension to an NV9607, it operates according to the mode in which the NV9607 is configured.
Following are brief instructions on how to perform a take under the various cases.
Case 1 — Stand-Alone Panel, Single-Destination Mode
The single destination is the one defined as the default destination. Takes all-level.
Press a source button to perform (and complete) a take.
Case 2 — Stand-Alone Panel, X-Y Mode
Takes all-level. Follow these steps:
1 Press a destination button.
2 Press a source button to perform (and complete) a take.
Case 3 — NV9607 Extension, Single-Destination Mode
Takes in single-destination mode are all-level. Follow these steps:
1 Verify that the default destination appears in the ‘Destination’ field of the display.
2 If the ‘Destination’ field does not show the default destination, of course, a problem exists.
Perhaps the panel is malfunctioning or not configured properly or perhaps the destination
has been removed from the NV9000 system. Any of these conditions is rare and the remedy
will depend on your system.
3 If source preview mode is off, press a source button to complete the take. (Optionally press
‘Source Shift’ to toggle between the two source sets.) The ‘Status’ field of the display shows
the source you chose.
4 If source preview mode is on, press a source button. (Optionally press ‘Source Shift’ to toggle
between the two source sets.) The ‘Preview’ field of the display shows the source you chose
and the take button turns red. If that is the correct source, press a ‘Take’ button. If it is not the
correct source, you can press another source and then press a ‘Take’ button.
Case 4 — NV9607 Extension, Single-Destination Mode, Breakaway
Takes in single-destination mode with breakaway are meant to be on selected levels. Follow
these steps:
1 Verify that the default destination appears in the ‘Destination’ field of the display.
2 Press one or more level buttons to selected the levels you want to route. The levels that are
available are those of the default destination. If your panel has a ‘None/All’ button, you can
press that button to toggle between all levels being selected and no levels being selected.
3 If source preview mode is off, press a source button to complete the take. (Optionally press
‘Source Shift’ to toggle between the two source sets.) The ‘Status’ field of the display shows
the source you chose.
4 If source preview mode is on, press a source button. (Optionally press ‘Source Shift’ to toggle
between the two source sets.) The ‘Preview’ field of the display shows the source you chose