Grass Valley NV9606 v.1.1 - Manual (Page 15)

5
NV9606
User’s Guide
Single-Destination Mode with Breakaway
In this mode too, the single destination is configured as the default destination. There are no
destination buttons.
Pressing a source button completes a take unless the corresponding NV9607 has a ‘Source
Preview’ button and it is active (high-tally).
Breakaway is possible in this mode if the panel has level buttons. Level buttons selected the
levels on which the take is to occur. Takes occur on all levels when either no levels are selected
or when all levels are selected.
Multi-Destination Mode
In this mode, source buttons are configured with destinations as well as sources. Thus, each
source button completes a route to an individual destination. If each button had a different
destination, it would be possible to route to 116 destinations. The typical configuration would
have fewer destinations.
Pressing a source button completes a take unless the corresponding NV9607 has a ‘Source
Preview’ button and it is active (high-tally).
Takes are all-level.
Secondary Modes
The NV9606 of itself has no secondary modes.
The NV9606 has a limited self-test capability, but no setup mode in which to change its panel ID.
To change the panel ID, you must use NV9000-SE Utilities.
Other NV9606 Functions
By itself, the NV9606 can be configured to perform two additional functions:
• System salvos.
As an NV9607 extension, the NV9606 can be configured to perform the following additional
functions:
• System salvos.
• Broadcast data routing.