Grass Valley NV9642 v.1.2 - Manual (Page 22)

12
Installation
Testing
tion exists for that panel and the buttons appropriate for that configuration should light in
the colors appropriate for the top-level button page of that configuration.
If you continue to see “No Server,” “Acquiring IP Address,” or “Locating Network” on button 2,
you have a problem. Reboot everything and try again.
 The NV9642, by default, acquires its IP address through DHCP on the system controller’s
panel/router network. You can use the Panel IP Configuration Utility to force the panel to
have a static IP address.
If (in setup mode) you do not see your designated panel ID on the display, you have either
not initialized the panel or no configuration has been created for your panel in NV9000-SE
Utilities.
3 Is the system controller actually running? With the typical noise levels in a facility, it can
sometimes be difficult to tell. Use the ‘System’ pages of NV9000-SE Utilities to make the
determination.
4 Is NV9000-SE Utilities installed and operating? If so, can you upload a configuration to the
specified panel?
5 Does the configuration actually work? Is it useful? Can the operator perform takes and per-
form other operations?
The design of an NV9642 “operator interface” is non-trivial. You might want to consider how well
your operator interface works in addition to the basic question of whether it works.