England's Stove Works 25PAH - Manual (Page 23)

23
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
THERMOSTAT OPERATION
Thermostat Operation Details
 The 25‐PAH was designed to operate equally well in both manual and thermostat mode.
While using the control board for heating control gives the user control over the heat
output of the stove, the thermostat allows the stove to “start‐up” and “shutdown”
independently, which will help maintain your house at a more constant temperature
and save pellet fuel.
 This pellet stove can be connected to either a wall thermostat (Part # PU‐DTSTAT) or
wireless remote thermostat (Part # AC‐3003). Although either thermostat will operate
the stove properly, we highly recommend the wireless thermostat for the convenience
of starting your pellet stove from anywhere in the house.
 Remember to locate the thermostat near the stove in a central location; putting the
thermostat in a distant room can cause the stove to overheat the room it’s located in
because the thermostat will only sense the temperature of the room in which it is
located.





 OPTIONAL ACCESSORIES
Wall Thermostat (PU‐DTSTAT)
 Installing this wall thermostat allows the 25‐PAH to operate on the same principle as a
furnace: The stove will shut‐down and relight as the call for heat comes and goes (in
On/Off mode, see above). This will maintain the house at a more constant temperature,
while conserving pellets.
Remote Thermostat (AC‐3003)
 The remote thermostat for the 25‐PAH takes the convenience of thermostat operation
one step further by allowing temperature adjustments from anywhere in the home. The
remote thermostat allows precise temperature control from wherever you desire and
only requires six (6) AA batteries to operate.
THERMOSTAT OPERATION: This stove is equipped with a unique, new feature that allows two options
for thermostatic operation: The stove comes from the factory pre‐programmed in “On/Off mode,”
which turns the stove on and off when the call for heat comes or leaves, like a furnace. The second, or
“High/Low mode,” burns at whichever heat range you set the stove at until the call for heat leaves, at
which point the stove goes to the Low heat range setting.
To set the stove in the “High/Low mode,” unplug the unit and plug it back in, then press and release
both down arrows; H L appears in the heat range and blower speed windows. The unit is now in
“High/Low mode.” (Note: Repeat this to change back to “On/Off mode;” a 0 0 will appear in the heat
range and blower speed windows). Using a thermostat in On/Off mode may shorten the life of your
stove’s igniter.