Grass Valley M-Series iVDR Service Manual - Manual (Page 57)

6 July 2004 M-Series Service Manual 57
Restoring from the software recovery disk image
11. On the Select Destination Partition… screen, from the partition list select Local
Disk .
This is the system drive, which should be at the top of the list and reported as Active
in the Status column.
12. Click Next . A dialog box is displayed that informs you that the existing partition
will be deleted before your image file is restored. Click OK . The Ready to Restore
Image File screen appears.
13. On the Ready to Restore Image File screen, all the information you have entered to
this point is displayed. Confirm that your are restoring from the disk image file on
the second partition to the iVDR system drive location. Click
Finish to begin
restoring from the image file.
14. The Restoring the Image dialog appears, tracking the progress of the image restore.
Upon completion, the following message appears: “Image was restored
successfully.”
15. Click Yes, return to the ImageCenter main screen, and exit the DeployCenter
program.
16. Remove the CD and use the standby switch to restart the iVDR.
The iVDR should start in Storage Maintenance mode, if you made the disk image
as instructed in
“Creating the software recovery disk image” on page 50 . If the
iVDR starts in Normal mode, from AppCenter select System | Shutdown . Then in
the Shutdown dialog select Storage Maintenance and OK to restart in Storage
Maintenance mode.
17. Open the Storage Utility and restore the Media File System from the backup file
you copied to the second partition at the beginning of this procedure. Refer to
“Restoring the media file system” on page 63 .
18. Close the Storage Utility and restart in Normal mode.