Grass Valley Kaleido-RCP2 Dec 16 2014 - Manual (Page 25)

15
Kaleido-RCP2
Guide to Installation and Operation
Enabling/Disabling the Kaleido-RCP2 User Interface
The PANEL ENABLE button cycles the Kaleido-RCP2 between ENABLE and DISABLE modes.
In the DISABLE mode
• The PANEL ENABLE LED is flashing.
Action LCD indication Other buttons
Press LOGIN. Until the unit receives the list of
login positions from the Kaleido
system:
Acquiring login list... Lit (depending on the
Kaleido system’s
configuration)
Once the list of login positions
is available:
LOGIN Position
[first list item] Digit keys 2 and 8 are
lit to indicate that they
can be used to scroll
the list
If the list of login position is not
available, the following
message displays for 3 seconds:
No login list available Lit (depending on the
Kaleido system’s
configuration)
If the Kaleido system is not
active, the following message
displays for 3 seconds:
Target system is offline Dimmed (depending
on the Kaleido system’s
configuration)
Press 8 repeatedly to scroll the list
until you reach the position you
wish to log on to, and then press
ENTER to select the new position. Enter password: Digit buttons are lit as
well as the ENTER and
ESC buttons
Type the password using the digit
keys (up to 8 digits), and then press
ENTER. Enter password:
****
(one asterisk appears for each
digit you type)
If the password is valid, the
following message displays for
2 seconds:
Access granted
and then:
RMC
TC01 Dimmed (depending
on the Kaleido system’s
configuration)
If the password is wrong, the
following message displays for
2 seconds:
Access is denied
and then:
RMC
TD01 Lit (depending on the
Kaleido system’s
configuration)