Grass Valley Kaleido-RCP2 Dec 16 2014 - Manual (Page 20)

10
Kaleido-RCP2
Restoring Default Parameters
connections to Kaleido systems in its own subnet.
To configure a unicast IP address on the Kaleido-RCP2, do the following:
1 Press and hold the ENTER button until the ESC button lights up to access the
Configuration menu.
2 Select ETHERNET OPTIONS on the LCD display, and then press ENTER.
3 Select Unicast host IP, and then press ENTER.
4 Select Enable IP 1, and then press ENTER.
The Enable IP n parameter instructs the Kaleido-RCP2 to query the Kaleido system at
the selected IP address for a list of rooms.
5 Select Host IP ADDR, and then press ENTER.
6 Using the numeric keypad, type the IP address of a Kaleido system on a remote subnet,
and then press ENTER.
7 Repeat step 4 to step 6 to add unicast IP addresses for up to three remote Kaleido
systems.
Restoring Default Parameters
The Kaleido-RCP2’s Configuration menu provides an option to restore the device’s default
parameters. This option is called FACTORY DEFAULT.
Select this option to revert the following elements to their default values:
• The network parameters.
• The room selection.
• The login position.
Once you exit the Configuration menu, the device will restart.
Here are the default parameter values:
Notes
• To navigate the Kaleido-RCP2 menu, press the 2 key to move up, or the 8
key to move down.
• There is no need to configure unicast IP addresses for Kaleido systems on
the same subnet as the Kaleido-RCP2 .
DHCP Enable
IP address 10.0.3.191
Subnet mask 255.255.0.0
Gateway 0.0.0.0
Unicast IP addresses All three host IP address parameters set
to 10.0.3.70 and disabled by default