Grass Valley Kaleido-RCP2 Dec 16 2014 - Manual (Page 23)

13
Kaleido-RCP2
Guide to Installation and Operation
2 Press ENTER to select the first option: ROOM SELECTION, and then wait until the room
list is downloaded to the Kaleido-RCP2.
3 Once the room list is available, press 8 repeatedly until System\Updater appears on
the LCD display (press 2 to move back if necessary), and then press ENTER.
4 Press the LOGIN button twice, and then wait until the position data is downloaded to
the Kaleido-RCP2.
5 Once the position data is available, select the position Update Now!, and press ENTER.
The Kaleido-RCP2 prompts you for a password.
6 Type “6472632” (i.e., “Miranda”), and then press ENTER.
The Kaleido-RCP2 downloads the new firmware from your PC. Progress information is
shown in the Status section of the Kaleido-RCP2 Updater window on your PC.
The Kaleido-RCP2 validates the data, copies it into the main memory and then reboots.
You can follow the progress of this step on the Kaleido-RCP2 screen.
7 Once the Kaleido-RCP2 has rebooted following the successful firmware upgrade, click
Next in the Kaleido-RCP2 Updater window, on the PC.
The final screen includes instructions for verifying that the new firmware is installed
and functional:
Verification (step 3 of 3)
To verify that your RCP2 is updated properly
1 On the Kaleido-RCP2, press and hold ENTER until the ESC button lights up, to access the
Configuration menu.
2 Select the option DEVICE INFO, and then press ENTER.
Note: If a network problem occurs and the Kaleido-RCP2 stops
downloading the firmware, go back to step 5 .
IMPORTANT
Transferring the new firmware data to the main memory takes several
minutes. Do not disconnect the Kaleido-RCP2 while it is updating its
firmware, as this may result in a fatal error. In this event, it will be necessary
to return the unit to Grass Valley to be reprogrammed.