Grass Valley Kaleido-MX (3RU) v.7.80 - Manual (Page 37)

23
Kaleido-MX (3RU)
Hardware Description & Installation Manual
status menu reports that an update is in progress, then you know that you should not
interrupt this process (by reseating the card, for example).
Input card power LED
Monitors the status of the 1.8V and 3.3V power supplies on board the Kaleido-MX card.
SDI LEDs
This group of LEDs monitors the status of the 16 inputs on the Kaleido-MX input cards. The
frame door must be open for the LEDs to be visible.
ABT/MADI LED
This LED monitors the status of the ABT/MADI input on the Kaleido-MX input cards.
REF LED
This LED monitors the status of the REF input on the Kaleido-MX input cards.
Boot status LED 1
Monitors the status of the firmware.
LED Meaning
Green OK
OFF Failure of the 1.8V or 3.3V on-board PSUs
LED Meaning
Green SD-SDI, HD-SDI or 3G input signal detected
Red No input signal detected
LED Meaning
Green ABT/MADI signal detected
Red No signal detected
LED Meaning
Green Black-burst or tri-level-sync signal detected
Red No signal detected
LED Meaning
Green Normal (firmware has completed initialization and communication
was established with at least one output card)
Blinking orange Error or no communication with an output card
Blinking green/red Transitory state during firmware initialization
Red Initial state