Grass Valley K2 Dyno S Quick Start v.3.0 - Manual (Page 12)

Chapter 1 Installation Configure network
K2 Dyno S Replay System 12 Quick Start Guide
4 December 2012
Configure network
Dyno-Pack Default IP Addresses
A Dyno-Pack, consisting of a Dyno S Controller paired with a K2 Summit(3G)/Solo(3G),
ships with static IP network addressing
Configure to facility network
The Dyno-Pack default IP addresses will work if the K2 Summit system and Dyno S
Controller operate on an isolated network. These values will probably need to be changed
to be compatible with your facility’s existing network.
Use standard Windows operating system procedures on both the K2 Summit system and
the Dyno S Controller to configure each with a static IP address on the same subnet. You
can also configure a host name if desired.
Configure K2 Summit system channels
The K2 Summit system channels may need to be configured for your required formats and
resolutions.
1. If necessary, open AppCenter, either by clicking on its icon on the desktop or selecting
the application in the Windows Start menu.
2. Logon to the AppCenter application with the administrator account. If a licensing
message appears, refer to K2 Release Notes.
The default K2 administrator account is the same as the Windows logon:
• Username: Administrator
• Password: adminGV! (The password is case sensitive)
3. Click System / Configuration. The Configuration System pane appears.
Device Default Static IP Address Subnet
Dyno S Controller 192.168.40.155 255.255.255.0
K2 Summit system 192.168.40.156 255.255.255.0