Grass Valley K2 Dyno S Quick Start v.3.0 - Manual (Page 11)

Chapter 1 Installation System startup
K2 Dyno S Replay System 11 Quick Start Guide
4 December 2012
System startup
Start up K2 Summit 3G Client
1. Press the Standby button on the front of the K2 Summit to activate the unit.
2. Power up the computer monitor connected to the K2 Summit.
3. Log on to the K2 Summit with the default Windows administrator account:
• Username: Administrator
• Password: adminGV! (The password is case sensitive)
4. At first startup, End User License Agreements appear on the K2 Summit computer
screen. Accept the agreements to continue.
The Power LED goes on and stays on. The Service LED stays off. Startup processes
complete in approximately two minutes and the K2 Summit is ready for connection and
operation.
Start up Dyno S Controller
1. Press the Standby button on the rear of the Dyno S Controller to activate the unit.
2. Power up the computer monitor connected to the Dyno S Controller.
The Dyno S Controller does not require a login, and will boot to the Dyno UI screen.
Press Standby
8681_03
Press
Standby
8681_04