Grass Valley K2 Dyno Installation v.1.6 - Manual (Page 24)

• Password: adminK2
(The password is case sensitive)
At first startup, End User License Agreements appear on the screen. Accept the
agreements to continue.
The Power LED goes on and stays on. The Service LED stays off. Startup
processes complete in approximately two minutes and the K2 system is ready
for connection and operation.
Disable write filter
Prerequisite:
• K2 software must be installed on the K2 Summit Production Client or K2 Solo
Media Server
1. If you have not already done so, log on to the K2 system with Windows
administrator privileges.
2. From the Windows desktop, click Start | All Programs | Grass Valley | Write Filter
Utility .
FBWF Manager opens.
3. Under Filter Settings, set Filter to Disable .
Do not modify other settings.
4. Click OK .
5. When prompted, restart the K2 system.
Configure network on K2 Summit/Solo
1. If you have not already done so, disable the write filter.
2. Access the Windows desktop on the K2 system. You can do this locally with a
connected keyboard, mouse, and monitor or remotely via the Windows Remote
Desktop Connection.
3. Open the Network Connections dialog box:
• In the Windows Classic view, select Start | Settings | Network Connections .
• In the Windows XP view, select Start | Control Panel | Network Connections .
4. Continue with standard Windows procedures to configure the TCP/IP protocol
properties. You can set up the network using DHCP, DNS, WINS, or other standard
networking mechanisms.
24 K2 Dyno Controller Installation Manual 13 April 2010
Configuring networks