Grass Valley K2 Dyno Installation v.1.6 - Manual (Page 12)

Comment Task
standard. On K2 Summit Production
Client, the license must be installed, if
not already present. Refer to release notes
for compatibility information and
upgrade instructions regarding K2
System Software and licensing.
Disable the write filter. Install Dyno Server software on K2
Summit/Solo
Refer to release notes for compatibility
information and upgrade instructions. Upgrade software, if necessary, on K2
Dyno Replay Controller
— Configure K2 Dyno Replay Controller
for connection to K2 Summit/Solo
Next: Refer to K2 Dyno Controller User Manual and K2 Dyno Replay System Quick
Start Guide for operation instructions.
K2 Summit/Solo system requirements
To support connection to a K2 Dyno Replay Controller, your K2 Summit Production
Client or K2 Solo Media Server must meet requirements as follows. Refer to
compatibility information in release notes for complete and updated requirements.
• Internal storage. K2 Summit Production Client with direct-connect storage or shared
storage (K2 SAN) is not supported.
• Depending on media formats required, a K2 Summit Production Client must have
appropriate licenses and/or hardware installed.
• The version of K2 system software must be compatible with the version of K2
Dyno software. Refer to release notes.
• AppCenter Pro license is required. On K2 Solo Media Server, the license is standard.
On K2 Summit Production Client, the license must be installed, if not already
present.
• On the K2 Summit Production Client or K2 Solo Media Server, in Configuration
Manager on the Ganging tab, make sure that
Record/play same clip on all channels
of Gang checkbox is not selected. In previous version this checkbox was labeled
"Use a single channel to control the gang".
• If using ChannelFlex Suite features, the K2 Summit Production Client or K2 Solo
Media Server requirements are as follows:
• K2 system software 7.2 or higher
• AppCenter Elite license
• Super Slo-Mo also requires the HD license
12 K2 Dyno Controller Installation Manual 13 April 2010
Overview of systems