Grass Valley K2 Dyno Installation v.1.6 - Manual (Page 11)

Installation instructions Description K2 system
Grass Valley preinstalls
software, licenses, and tests
the units together before you
receive the Dyno-Pack.
Refer to the appropriate
checklist and topics later in
this manual. A stand-alone K2 Summit
Production Client that is not
a part of a Dyno-Pack and
has not previously been K2 Summit Production
Client
controlled by a K2 Dyno
Replay Controller. You must
install and possibly license
software.
Refer to the appropriate
checklist and topics later in
this manual. Any K2 Solo Media Server.
You must install software. K2 Solo Media Server
The Dyno Director product requires software and configuration that is not documented
in this manual. Refer to Dyno Director documents.
K2 Summit/Solo with Dyno installation checklist
Comment Task
— Verify system requirements
Procure or verify supporting systems and
software Procure software and/or hardware
Refer to K2 Dyno Replay System Quick
Start Guide. Both the K2 Dyno Replay Unpack devices
Controller and the K2 Summit
Production Client come with their own
specific USB Recovery Flash Drive.
Make sure you keep each Recovery Flash
Drive with its own specific unit. Do not
lose the Recovery Flash Drive.
— Cable devices
Disable the write filter. Configure network on K2 Summit/Solo
— Configure network on K2 Dyno Replay
Controller
At the MS-DOS command prompt, use
the ping command. Verify network communication
AppCenter Pro license is required. On
K2 Solo Media Server, the license is Upgrade and/or license software, if
necessary, on K2 Summit/Solo
13 April 2010 K2 Dyno Controller Installation Manual 11
Overview of systems