Grass Valley Jupiter Control System - Manual (Page 15)

13
The factory-configured set will usually contain all switcher levels with the name of the
switcher (i.e., VENUS, TRINIX, TRITON, MARS, etc.), otherwise it will have a
switcher name of DEFAULT. Once again, making minimal changes to this table at
this time is advised. Possible changes may be to switcher names or level names.
More involved customizing of this table can be done in later steps. (Thomson does
not recommend changing the switcher names if the Switcher Input and Output
tables have already been customized.) When finished, click OK. See the Switcher
Description subheading under section 5 of the Jupiter manual for more details about
this table.
Step 8
Open the Switcher Input table:
The factory-configured set will contain numeric representations for all source
designations. Enter the mnemonic names for the sources. Note that a switcher will
have several levels associated with it and columns of numbers for each level (the
column headings are taken directly from the Switcher Description table). These are
“crosspoints-to-switch” numbers and can be modified at this time if necessary.
Example:
In this example, “BARS” will switch crosspoints 000 for all the levels.