Grass Valley FIO-1901-RR - Manual (Page 9)

GUIDE TO INSTALLATION AND OPERATION
FIO-1901-RR | 5
Rear adapter:
The FIO-1901-RR-SRP rear panel requires the following adapter for use in a Densité-3 frame:
DENSITE
SRP-3RU
Installing the adapter and connector panel
Install the adapter and the rear panel as follows:
1. Position the adapter at the top of the empty
slot on the rear of the frame.
2. Use the captive screw in the adapter to
fasten it securely in position.
3. Slip the top of the rear panel into the slot at
the bottom of the adapter, and secure it to the
frame using the captive screw at the bottom of
the panel.
Installing the card
Once the rear connector panel has been installed,
insert the FIO-1901-RR card with attached adapter
as follows:
1. Open the front panel of the frame.
2. Slide the FIO-1901-RR card into the slot with
the swivel handle at the top, and push gently
on the handle to seat the connectors.
3. Close the front panel of the frame.