Grass Valley FIO-1901-RR - Manual (Page 10)

GUIDE TO INSTALLATION AND OPERATION
6 | FIO-1901-RR
2.3 Rear Connector Panel
The FIO-1901-RR-SRP single-slot rear panel, mounted in a Densité 2 or Densité 3 frame, incorporates these
connectors:
• One socket for inserting a fiber receiver SFP module – see the list of supported modules below.
• Two BNC connectors for the 3G/HD/SD SDI outputs.
2.4 SFP Modules
The FIO-1901-RR supports the following SFP optical interface modules:
FIO-1901-RR Model # Description of associated SFP module
FIO-1901-RR-LC Dual 3G/HD/SD Optical Receivers - LC/PC Connectors
FIO-1901-RR-W-LC Dual 3G/HD/SD Optical Receivers with WDM - LC/PC Connector
See ANNEX 2 – Installing the Optical Interface, beginning on page 21, for instructions on installing and removing SFP
modules.
Note that when the WDM (Wavelength Division Multiplexing) module is installed, the two input signals are multiplexed
onto a single optical fiber.
Figure 2.1 FIO-1901-RR-SRP Rear Panell