Grass Valley EDIUS 5 - Manual (Page 18)

Connecting to HDBX
For EDIUS SD / HD only.
POINT See the following sections for the combination of EDIUS HD + HDBX-
1000H and EDIUS SD + HDBX-1000S.
"Setting HDBX connecting terminal" P16
"Connecting HDBX" P21
See the following sections for the combination of EDIUS SD + HDBX-
1000S + HDBX-UG.
"Setting HDBX connecting terminal" P16
"Upgrading HDBX" P20
"Connecting HDBX" P21
•
•
Setting HDBX connecting terminal
To connect HDBX to the RX-E1 board, you need to replace the SDI terminal of the RX-
E1 board with the HDBX connecting terminal. This section explains how to remove the
RX-E1 board already set in PC and how to replace the terminal. When the RX-E1 board
is not set in PC, see from step 4.
Notes Static electricity can damage electronic components. Take care not to
touch connectors or cards directly. When installing or working on your
PC, first touch a grounded metal surface. This will discharge any static
electricity on your body. •
1
Shut down Windows and unplug the power cable of your PC
before installation.
2
Remove the cover of your PC.
3
Remove the RX-E1 board and the remote terminal.
Remote terminal
RX-E1 board
►