Grass Valley 3-CCD ANALOG CameraMan Rev.B - Manual (Page 26)

Page 23 Appendices
Appendix G: On-Screen Camera Menus
The fourth on-screen menu is the System Setup menu
MEM. BANK [A, B] Initial Setting: A
Two different sets of settings can be stored in the camera, and then switched between
depending on the shooting conditions. These are stored in memory bank “A” and memory
bank “B”. The selected memory bank is shown in the upper right hand corner of the menu.
MEM. PROTECT [ON, OFF] Initial Setting: off
Each memory bank can be protected by setting the MEM. PROTECT to ON. When the bank is
protected, the memory bank indicator will be flashing.
Note: The following items can be changed even if the memory bank is protected:
GAIN, SHUTTER, C. TEMP, WHT. BALANCE, MEM. BANK, MEM. PROTECT, DATA
SEND
DATA SEND [A --> B, B --> A] Initial Setting: A-->B
The camera settings can be copied from one memory bank to the other.
D-SUB OUT [VBS/YC, RGB/COMP] Initial Setting: VBS/RGB
VBS: Changes the output of the RGB/SYNC connector on the camera to VBS output.
YC: Changes the output of the RGB/SYNC connector on the camera to Y/C
(S-video) output.
RGB: Changes the output of the RGB/SYNC connector on the camera to RGB output.
COMP: Changes the output of the RGB/SYNC connector on the camera to Component
Video output.
BAUD RATE [9600, 4800, 2400, 1200] Initial Setting: 9600
Changes the baud rate of the REMOTE connector on the camera.
Note: This setting should always be set to 9600. Changing this setting may impact
the camera’s communication links.
FLASH [OFF, MASTER, SLAVE] Initial Setting: off
This should always be set to OFF.
PRINTER [ON, OFF] Initial Setting: off
This should always be set to OFF.
>4. System Setup :A
Mem. Bank A
Mem. Protect off
Data Send B->A
D-Sub out VBS
Component
Baud Rate 9600
Flash master
Printer Trig. off
System Startup Menu