Grass Valley 3-CCD ANALOG CameraMan Rev.B - Manual (Page 16)

Page 13 Use Your 3-CCD Camera System
System Startup
Once all necessary connections and configurations are made, you are ready to turn on the system.
Powering On
1. Just switch the Power button on the back of the CameraMan Camera to the ON position.
The Camera should automatically enter its position calibration mode and then stop at the
zero degree point.
2. Verify that the camera is now facing in the direction the "FRONT" label was pointing during
mounting (see page 7).
3. If you are using the optional Camera Control Keypad or Shot Director, make sure its base
unit address is the same as on the camera. If they are, verify that the camera’s PAN and
TILT functions are working properly.
Tip: If the camera does not move, refer to the TROUBLESHOOTING section
ofyour Camera Control Keypad, or Shot Director manual.
Back of CameraMan with
power supply