Grass Valley 3-CCD ANALOG CameraMan Rev.B - Manual (Page 17)

Page 14 CameraMan ® 3-CCD Camera System Installation and Operations Manual
Appendix A: Troubleshooting
Should you have any problems with your CameraMan General Pan/Tilt Camera System, please refer to the following guide. If you
still have questions or problems after troubleshooting, please contact your authorized reseller or contact Grass Valley.
Problem: The Camera’s Video is not working properly.
Solution: 1. Verify that the VIDEO SELECT switch on the back of the
Camera is set properly. (see page 12)
2. Verify that the appropriate video connection is
being used on the back of the camera, either
S-VIDEO or COMPOSITE VIDEO OUT. (see page 8)
3. Verify that the video output of the camera is connected to the
appropriate video input on the switcher or CODEC.
Problem: No communications through the RS-232 port.
Solution: 1. Verify that the cable being used is wired correctly. (see page 17)
2. Verify that the PROTOCOL SELECT switch on the back of
the Camera is set properly. (see page 12)
3. Verify that the BASE UNIT ADDRESS switch is set properly.
4. Does the COM light above the RS-232 port on the back of
the camera blink when you send a command through this
port? If no, change the cable and retry.
Back of 3-CCD CameraMan
COM light on
RS-232
Connection