Grass Valley 3-CCD CameraMan Rev A - Manual (Page 30)

3-CCD DIGITAL Camera
Page 27
Appendix H: On-Screen Camera Menus
Neither Sharpness nor Super DTL is valid for contour
correction if Detail Level setting
is in the OFF posi-
tion.
Detail Level Setting [Level: OFF/LOW/HIGH]
Detail level can be adjusted when Detail Select set-
ting
is at Sharpness. Super DTL level can be
adjusted when it is at Super DTL.
In case of using the RCU (RCB), the above can be
adjusted with the contour correction switch (DTL).
Noise Suppress Level Setting [Noise Suppress:
OFF/LOW/HIGH]
Screen noise can be reduced when Detail Level set-
ting
is at HIGH or LOW.
Clean DNR Setting [Clean DNR: OFF/LOW/HIGH]
Clean DNR effect can be selected.
Detail Flesh Tone Level Setting [DTL Flesh Tone:
LOW/MID/HIGH]
LOW:
Skin color coarseness is suppressed.
MID: Standard
HIGH: Skin color is emphasized.
Electronic Shutter Setting [Shutter Speed: OFF/
1/100 to 1/10 000 / S/Scan / Auto ND]
OFF: Electronic shutter is turned off.
1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, 1/10 000:
Electronic shutter operates at one of these
speeds as selected.
S/Scan (Synchro Scan): Electronic shutter operates
at the speed set with the electronic shutter syn-
chro-scan setting
.
Auto ND: Electronic shutter is controlled to automati-
cally adjust the luminance. (ELC)
Note
Highlight Chroma Setting [Highlight Chroma:
OFF/LOW/HIGH]
At LOW or HIGH, the color dynamic range widens to
prevent highlighted white portions from suppression.
Color Bar Setup Setting [Color Bar Set:
0.0 IRE/7.5 IRE]
The setup level of color bar can be adjusted.
Horizontal Phase Adjustment
[H Phase: –206 - +49]
Horizontal phase can be adjusted when a genlock
signal is supplied.
Sub Carrier Phase Coarse Adjustment
[SC Coarse: 1/2/3/4]
Coarse adjustment of subcarrier phase can be made
when a genlock signal is supplied.
Subcarrier Phase Fine Adjustment [SC Fine: –511
- +511]
Fine adjustment of subcarrier phase can be made
when a genlock signal is supplied.
Detail Select Setting [DTL Select: Sharpness/
Super DTL]
If contour correction is not sufficient at the Sharpness
position when Detail Level setting
is set to LOW or
HIGH, select the Super DTL position.
• In case of using the RCU (RCB), none of the shutter
speeds-1/250, 1/2 000, 1/4 000, and 1/10 000 can
be selected.
• In case of using the hybrid control panel, only OFF,
1/100, or Auto ND (ELC) can be selected.
• If the lens iris switch is at M (Manual) when operat-
ing the camera alone or when the iris switch on the
RCU (RCB) is at AUTO, Auto ND may not function.
Set the lens iris switch to A (Auto).
• Flickering may increase at Auto ND under fluores-
cent lights.
• Auto ND is automatically selected if Auto ND (ELC)
setting is set to ON.
Notes