Grass Valley 3-CCD CameraMan Rev A - Manual (Page 17)

Page 14
CameraMan® 3-CCD DIGITAL Camera Installation and Operations Manual
System Startup
Once all necessary connections and configurations are made, you are ready to turn
on the system.
Powering On
1. Just switch the Power button on the back of the CameraMan DIGITAL
Camera to the ON position. The Camera should automatically enter its
position calibration mode and then stop at the zero degree point.
2. Verify that the camera is now facing in the direction the "FRONT" label was
pointing during mounting (see page 7).
3. If you are using the optional Camera Control Keypad or DIGITAL SHOT
Director, make sure its base unit address is the same as on the camera.
If they are, verify that the camera’s PAN and TILT functions are working
properly.
Tip: If the camera does not move, refer to the
TROUBLESHOOTING section of the Camera Control Keypad, or
DIGITAL SHOT Director manual.
If using more than one CameraMan 3-CCD DIGITAL Camera,
they need to be set up in a “daisy-chain” network
Back of DIGITAL Camera
with power supply