Grass Valley 3-CCD CameraMan Rev A - Manual (Page 10)

3-CCD DIGITAL Camera
Page 7
Switch Bank A
Switch 7 (Baud Rate Switch)– Used to change the camera’s Baud Rate.
Switch 8 (Memory Lock Select Switch)–Can be used to prevent
programmed settings from being accidentally overridden.
Switches 1, 2, 3, 4, 5 and 6— Reserved for future use.
Center Control Switches
Video Select Switch–Non-functional.
Base Unit Address–Used to configure the address of the
Camera.
Switch Bank B
Switch 1 (Protocol Select Switch) – Used to select the type of
Protocol being used for RS-232 and RS-485 communications.
This can be configured as either Basic or High Reliability.
Switch 4 (RF Commands Switch) – Used to enable or disable
the RF Receiver in the CameraMan camera.
Switch 5 (Preset Save) - Used to determine how the preset settings
will be saved.
Switch 8 (Interlink Switch) – Used to disable commands from being sent
on the RS-485 bus to other CameraMan devices.
Switches 2, 3, 6 and 7— Reserved for future use.
Tally Light Interface Port- Provides output and external control for
CameraMan Tally Light.
CameraMan Configuration Switches
Behind the configuration plate on the lower right side rear of the 3-CCD DIGITAL Camera
is the configuration panel. These DIP and rotary switches are used to link the camera’s
settings to other components in the system.
Back of 3-CCD
DIGITAL Camera
Note: After changing any switch’s settings, turn the camera off, then
back on to activate the change. Refer to page 12 for Dip Switch
configuration.