Grass Valley 3-CCD CameraMan Rev A - Manual (Page 29)

Page 26
CameraMan® 3-CCD DIGITAL Camera Installation and Operations Manual
Appendix H: On-Screen Camera Menus
• In case of settings on the camera alone or when the
iris switch on the RCU (RCB) is at [AUTO], the Auto
Gain Up control may not operate if the lens iris
switch is in the manual position.
• When the AGC switch on the hybrid control panel is
set to AGC, the Auto Gain Up control operates in
the HIGH position.
P O W E R
O P E R AT E
B A R
C A M
M O D E
G A I N A W C
SCENE
FILE
A B C
A T W
A
B
AUTO/AIW
E L C
L O W
M I D
M A N U
O N S C H
O F F
H I G H A G C
O F F
1 / 1 0 0
S H U T T E R
O N
O F F
1 . 2 . 3 . 4 .
G / L P H A S E
T. P E D C A B L E C O M P
9 0 ° 1 8 0 °
0 ° 2 7 0 °
Y C
Auto Gain Up Control Setting [Auto Gain Up:
OFF/ LOW/HIGH]
LOW: The Auto Gain Up control with a maximum
gain increase of about 18 dB adjust the lumi-
nance automatically.
HIGH: The Auto Gain Up control with a maximum
gain increase of about 30 dB operates. If the
luminance is still insufficient, the Night Eye also
operates to adjust the luminance automatically.
OFF: No auto gain up takes place. (Gain can be
increased manually.)
Hybrid Control Panel
AGC
Manual Gain Up Control Setting [Manu Gain Up: 0
dB - 30 dB / NIGHT EYE]
Manual setting is possible only when the Auto Gain
Up control is in the OFF position.
0 dB: 0 dB should be selected in normal cases.
1 dB - 30 dB: Use this range if sufficient video output
cannot be obtained even when the lens iris is
opened in shooting dark scenes.
NIGHT EYE (Night Eye L/H): Use this mode if suffi-
cient video output cannot be obtained even if 30
dB gain up should be selected.
Night Eye can be selected to any of two (L or H)
levels.
Black Level Setting [Pedestal: –30 - +30]
The black level (pedestal) of the luminance (Y) signal
can be set. Used in adjusting the black levels of two
or more cameras.
Contrast Adjustment [Contrast (Gamma):
LOW/MID/HIGH]
Contrast can be adjusted to any of three levels.
Chroma Level Adjustment
[Chroma Level: –3 - +3]
Chroma Level can be decreased or increased to any
of three levels each.
Skin Color Adjustment [Flesh Tone: –3 - +3]
Skin color can be decreased or increased to any of
three levels each.
White Balance Setting [White Bal: ATW/AWC A/
AWC B/P SET 3 200K/P SET 5 600K]
ATW: The white balance is automatically adjusted to
be always right.
AWC A, AWC B: Once the white balance is adjusted
with the ITEM/AWC switch on the back of the
camera, it is no longer necessary to set the white
balance again if you simply select AWC A or AWC
B, provided that the camera is used under the
same conditions.
Fine color adjustment can be made after setting
AWC by red/blue gain adjustment in user mode or
from the RCU (RCB).
P SET 3 200K: The white balance is adjusted to 3
200K illumination.
P SET 5 600K: The white balance is adjusted to 5
600K illumination.
Manual GAIN
Notes
• Only 0 dB, 9 dB, or 18 dB can be selected in case of
using the RCU (RCB).
• 0 dB when the manual GAIN switch on the hybrid
control panel is at LOW, 9 dB when it is at MID, or
18 dB when it is at HIGH.
P O W E R
O P E R AT E
B A R
C A M
M O D E
G A I N A W C
SCENE
FILE
A B C
A T W
A
B
AUTO/AIW
E L C
L O W
M I D
M A N U
O N S C H
O F F
H I G H A G C
O F F
1 / 1 0 0
S H U T T E R
O N
O F F
1 . 2 . 3 . 4 .
G / L P H A S E
T. P E D C A B L E C O M P
9 0 ° 1 8 0 °
0 ° 2 7 0 °
Y C
Notes
Hybrid Control Panel
Neither P SET 3 200K nor P SET 5 600K can be set
from the RCU (RCB) or the hybrid control panel.
Note