Grass Valley 3-CCD CameraMan Rev A - Manual (Page 12)

3-CCD DIGITAL Camera
Page 9
Connecting to the Camera System
Follow the instructions below to begin connecting the camera to the system.
Tip: After connecting each cable to the camera, let it hang
loosely behind the camera. Then follow the instructions in the
“Restraining the Cable Connections” section before attaching the
other ends of the cable to other equipment. This will relieve
undue stress on the cables, allowing the camera to move freely.
Connecting The Camera Control Cables
On the back of the camera shroud, there are two cables. These control
the camera’s lens, power and video signals. These must be attached for
the camera to operate properly.
• Connect the 12-pin male connector (#1) to the IRIS jack.
• Connect the 50-pin SCSI connector (#2) to the I/F REMOTE jack.
Connecting The SDI Video Output
The 3-CCD DIGITAL Camera supports SDI format (270 Mbls component
out).
Connect to the BNC jack labeled SDI OUT on the back of the camera
shroud, using a standard SDI coaxial cable with a BNC connector.
1
2
2
1
SDI OUT
Rear View of DIGITAL
Camera