Grass Valley 3-CCD CameraMan Rev A - Manual (Page 27)

Page 24
CameraMan® 3-CCD DIGITAL Camera Installation and Operations Manual
Appendix H: On-Screen Camera Menus
MENU ITEM SETTING
• Each of the four use modes of the camera has a main
menu. (Shown at right)
• Each item of the main menu has a submenu, which
consists of several settings.
• These settings have been preset to the optimum val-
ues to suit each use mode, and can be changed to
suit actual shooting conditions.
• They can be set from the camera and RCU (RCB).
They can also be set from the hybrid control panel
using the switches, but the setting items are limited
because the menu is not shown.
Notes:
• Composite signals are output from the video out-
put regardless of the position ENC/VF of the RCU
(RCB) user set switch.
• [End] is displayed only in setting from the camera
alone.
MAIN MENU SCREEN
Use Mode
Blinking
Main Menu of Halogen,
Fluorescent, Outdoor Mode
Main Menu of User Mode
SETTING
1. From the camera alone:
Keep the MENU switch depressed for 5 seconds
or more.
From RCU (RCB):
Set the user set switch in the pocket to the ON
position.
The main menu appears on the monitor screen.
2. Each time the MENU switch ( ), ITEM/AWC switch
( ), or NO/BAR switch (-) is
pressed, the blinking item moves up or down.
3. When the YES/ABC switch is pressed after selecting
the desired item to blink, the submenu for the select-
ed item appears on the screen.
4. Select the desired item to be changed in its settings
using the the MENU switch ( ) and ITEM/AWC
switch ( ).
5. Press the YES/ABC switch (+) or NO/BAR switch (–)
to change the settings.
6. Select [Return] using the MENU switch and ITEM/
AWC switch, then press the YES/ABC switch to
return to the main menu.
7. After changing the settings, take the following steps.
Camera alone: Select [End] using the MENU switch
and ITEM/AWC switch and press the YES/ABC
switch.
VIDEO OUT
G/L IN
I/F REMOTE
OPTION CARD
IRIS
DC12V IN
MENU
ITEM/AWC
YES/ABC
NO/BAR
MENU
ITEM/AWC
YES/ABC
NO/BAR
PAGE ITEM UP DOWN
COARSE FINE
SC PHASE
270 ° 0 ° H.PHASE
USER SET
OFF ENC
VF ON
USER SET SWITCH
RCU (RCB): Set the user set switch in the pocket to
the OFF position.
The camera will now operate according to the new
settings.
CAMERA
RCU (RCB)