Grass Valley ADVC-3000 - Manual (Page 48)

Chapter 2 - Basic Operations
48
107 video standard
Video standard settings
LCD display
Press the Select dial to display the sub-menu.
In the sub-menu, turn the Select dial to display the sub-menu in
turn.
Sub-menu
Select the video standard.
NTSC(525)/
0IRE
Sets to NTSC with the setup level of 0 IRE.
NTSC(525)/
7.5IRE
Sets to NTSC with the setup level of 7.5 IRE.
PAL(625) Sets to PAL.
SECAM(625) Sets to SECAM.
set by DIP
switch
Adopts the setting by the DIP switch on the rear panel.
(Factory default)
Specifi es the video standard. Once you have changed
the video standard settings (or the setup level), you
are prompted to turn the power off to make the new
setting take effect.
108 DVout frame sync
DV out frame synchronizer setting
LCD display
Disables the frame synchronizer. (Factory default)
Enables the frame synchronizer.
* Regardless of this setting, the synchronizer takes effect on the output analog video.
* The sync signal of the frame synchronizer is set in “109 Vout ref. select”.
* This option is invalid if “501 9P remote” is set to remote A or remote B.
Enables/Disables the frame synchronizer on the output
DV stream in SDI/ANALOG DV mode.
50