Grass Valley ADC-1722 - Manual (Page 13)

GUIDE TO INSTALLATION AND OPERATION
ADC-1722 | 13/22
3.4 Remote control using iControl
The operation of the ADC-1722 may be controlled using Miranda’s iControl system.
• This manual describes the control panels associated with the ADC-1722 and their use.
• Please consult the iControl User’s Guide for information about setting up and operating iControl.
In iControl Navigator or iControl Websites, double-click on the ADC-1722 icon to open the control panel.
The control panel window is divided into four sections, as shown in the figure:
Section 1: The header section shows the name of the product (ADC-1722) and identifies the slot in which it
is installed in its Densité frame (Slot 9 in the example).
On the left is the card status icon, reflecting the status of the card’s on-board alarms. See section 3.4.5 for
information about programming the card alarm system.
Section 2: This section shows status icons for six selected card parameters
Icon # 1 2 3 4 5 6
Move the mouse over an icon and a status message appears below the icon providing additional information.
If there is an error, the error status message appears in the message area without mouse-over.
• If there are multiple errors, the error messages cycle so all can be seen
• The icon whose status or error message is shown is highlighted with a mauve background
1
3
2
4