Grass Valley 8935CF - Manual (Page 17)

8935CF — Instruction Manual 17
Installation
Front Module Installation
After installing the rear module and SFP submodules on the front module,
install the front module as follows:
1. Remove the front cover of the frame.
2. Locate the corresponding front slot.
3. Before installing the module, set the Local/Remote onboard jumper as
described in
Local/Remote Jumper on page 25 .
4. Clean the fiber optic connections as described in the Fiber Optic Cleaning
Requirement on page 10 .
5. Insert the front module so that the plastic card guides on the module
top and bottom edges go over the upper and lower raised rail guides on
the right of the top and bottom of the slot (
Figure 9 ).
6. Carefully slide the module into the rear connector.
7. Lock the front module ejector tab into the locking pin.
8. Replace the front cover for configuring the module using remote
controls.
Figure 9. Front Module Installation
8543_02
Slide top and bottom card carriers on module
over top and bottom guides on right of slot.
Module installed
Locking Pin
Card Carriers
Card Carriers
Front Module Side View