Grass Valley 8916 User Manual
Page 18
12
8916 Instruction Manual
8916 AES/EBU Auto-Tracking Delay DA
The sum of the Coarse, Fine and Auto Tracking delay will appear in the
Total Delay display above the Coarse and Fine Adjust.
Below the Coarse and Fine Adjust displays are the following indicators
giving module information:
■
Auto Tracking Delay: Amount of auto tracking delay in mS from the
Frame Sync Delay Input BNC (J7).
■
Auto Tracking State: Enabled or Disabled.
■
Input Audio Errors: Audio OK, Out of Range, GT (Greater Than) 4
Percent 48K, GT 4 Percent 44.1K, or GT 4 Percent 32K.
■
Incoming Sample Rate: 48K, 44.1K, 32K or Invalid.
shows the display for setting the delay in Slider mode.
Set Coarse and Fine delay using the arrow keys to increase or decrease the
delay. The settings will default to an increment of 2 mS (Fine) or 32 mS
(Coarse). The single arrows will change the value by 1x and the double
arrows will change the value by 10x.
Use the Apply button to make the selections active.
The sum of all delay is shown in the Total Delay slider display.
The module information below the Coarse and Fine Adjust displays is
identical to the information explained in the Numeric section above.