Grass Valley 8900GEN-SM - Manual (Page 25)

8900GEN-SM — Instruction Manual 25
8900GEN-SM Applications
5. Set the following parameters on the Genlock web page under Genlock
Control:
• Genlock – Enabled
• Input Selection Standard – set the pulldown frame rate to match the
reference input exactly if possible or set to one of the compatible
frame rates given in
Table 1 on page 9 .
Setting the pulldown to a frame rate that does not match the refer-
ence input exactly will produce a warning message as shown in
Figure 8 on page 26 . The reference signal will still be locked as you
will note in the Genlock web page header. This is still a valid condi-
tion.
This warning message will also appear on the Status web page for
this host module as shown in
Figure 9 on page 27 . The Genlock Ref
In arrow from the host module and the Status LED on the top of the
page will be yellow, indicating a warning condition exists. This will
not affect the Locked condition.
• Loop Bandwidth – Fast Lock
6. Under Genlock Bus Timing, set all the timing controls (Line Offset,
Coarse Offset (37ns), and Fine Offset) to 0 (zero).
7. Set the Drive Frame Reference Bus to Auto .
8. On the Genlock web page, verify that the header reports the Status as
Locked and the Output Bus as Ref 1 .