Grass Valley 8900GEN-SM User Manual
Page 13
8900GEN-SM — Instruction Manual
13
Configuring the Genlock Submodule
The arrows referring to the reference signal in the upper graphic portion of
the Status web page header represent the following:
•
Genlock Ref In – this arrow indicates a genlock reference is connected
to the Genlock Loop on the host rear module. Clicking on this link will
open the host module I/O Config web page where a signal name can
be assigned to this input.
•
Genlock Module 8900GEN-SM – clicking on this link will bring up the
Genlock web page where the configuration of the Genlock submodule
can be performed. See
•
Local Ref – this arrow reports the presence and status of an input from
the Genlock Loop. This signal is available to the host module as a Local
reference processed on the Genlock submodule. Selecting this link
opens the host module System Config web page where the desired
output timing reference can be selected.
•
Ref 1 Out (to Frame) – this arrow indicates the Ref 1 frame bus is avail-
able from this module. Only the host module with a Genlock sub-
module installed in slot 1 of the frame has this arrow. Selecting this link
will bring up the host module I/O Config page.
Note
A host module with a Genlock submodule installed in slot 3 of the frame will
show this arrow as Ref 2 Out (to Frame).
•
Ref 1 In (from Frame) – this arrow represents the status of the Ref 1
frame bus. Clicking this link will bring up the Genlock web page for the
host module in slot 1 of the frame.
•
Ref 2 In (from Frame) – this arrow represents the status Ref 2 frame bus.
Clicking this link will bring up the Genlock web page for the host
module in slot 3 of the frame.