Grass Valley 2040RDA - Manual (Page 16)

16 2040RDA — Instruction Manual
Configuration
Remote Configuration and Monitoring
2040RDA configuration and monitoring can be performed remotely using
the 2000NET interface (see
Figure 7 ). This section describes the GUI access
to the module configuration functions. Refer to the 2000NET Network Inter-
face Module Instruction Manual for information on setting up and operating
the 2000 frame network.
For remote access, make sure jumper block J24 on the module is set for both
Local and Remote access (
Figure 6 on page 15 ).
Note The physical appearance of the menu displays shown in this manual repre-
sent the use of a particular platform, browser and version of 2000NET
module software. They are provided for reference only. Displays will differ
depending on the type of platform and browser you are using and the version
of the 2000NET software installed in your system.
Figure 7. 2000NET GUI
The 2000 modules can be addressed by clicking on a specific module icon
in the frame status display or on a module name or slot number in the link
list on the left.
0612-13
The Links section lists the frame and its current modules. The selected link's Status
page is first displayed and the sub-list of links for the selection is opened. The sub-list
allows you to select a particular information page for the selected device.
Content display section displays the information page
for the selected frame or module (frame slot icons are also
active links).