Install the passive rear module – Grass Valley 2040RDA User Manual
Page 11
2040RDA — Instruction Manual
11
Installation
Install the Passive Rear Module
1.
Install the Passive Rear module first by inserting it into any rear slot
(1 – 12) of the frame as illustrated in
.
Figure 2. Installing Passive Rear Module
2.
Verify that the module connector seats properly against the midplane.
3.
Secure the module to the rear of the frame with the two screw locks on
either side of the back panel using a crossblade screwdriver.
Figure 3. Installing Front Media Module
4.
With the component side up, insert the front media module in the
corresponding front slot (see
).
5.
Verify that the module connector seats properly against the midplane
and rear module connector.
6.
Press firmly on both ejector tabs to seat the module.
Alignment post
and receptacle
Screw lock
(both sides)
8026_05
r1
2000 frame (rear view)
Board edge guides
(both sides)
J10
J9
SIG
J8
J7
J6
J5
J4
J3
J2
J1
In
COAX
PRM
2040RDA
Alignment post and receptacle
8026-07
2000 Frame (front view)
Board edge
guides
Board edge
guides