Grass Valley 2040RDA - Manual (Page 12)

12 2040RDA — Instruction Manual
Installation
Cabling
All cabling to the 2040RDA module is done on the corresponding Passive
Rear module at the back of the 2000 frame. Refer to
Figure 4 for a detailed
illustration of the rear connections referenced in the steps below.
Input
Connect an HD or SD video input to BNC J10. The 2040RDA will accept any
of the serial digital component video signals conforming to the following
SMPTE formats:
• SMPTE 292M
• 259M (143 Mbps, 177 Mbps, 270 Mbps, 360 Mbps)
• EBU 1697
• 4 Mbps to 1.5 Gbps (tested with PN20 pseudonoise sequence ratio,
maximum 19:1)
• SMPTE 310M
• DVB-ASI
Outputs
The input signal is distributed to eight output ports. Connect video output
devices to outputs J2 through J9 provided on the Coax Passive Rear
module.
Note BNC J1 is not used on this module. On earlier versions of the 2040RDA
labeled with part number 671-4962-00, BNC J1 provided an output.
Figure 4. Coax Passive Rear Module Input/Output Connectors
8026_03r1
J10 J9
SIG
J8 J7 J6 J5 J4 J3 J2 J1
IN
COAX
PRM
Outputs Video
Input Not
Used Signal Present
LED